What screen does Delta have?
A, AE screen COM1 for example: screen 1, 2, 3, 4, 5 connected to Mitsubishi corresponding 4, 7, 2, 1, 3, Delta can download programs with AB USB line.

This is the communication cable connection diagram of Mitsubishi Q series PLC and Fuji V series touch screen, 232 communication method

Communication problem, if it is RSC85 communication, there may be interference caused by communication signal error, if it is RS232, please replace the communication line. RS232 is relatively stable, it is recommended to use

Using the online simulation function of Delta’s touch screen programming software DOPSoft 1.01.10

Make sure that the communication module on Mitsubishi PLC is the 422 protocol.

Make sure that Delta’s touch screen program communication protocol is 422 protocol.

Prepare a serial cable.
Connect PLC and touch screen

Then you can communicate.

Be sure to ensure that the PLC is consistent with the touch screen communication protocol (protocol, baud rate, parity, etc.).

Yes, for example FX-USB-AW USB interface Mitsubishi FX series PLC programming cable, USB/RS422 interface adapter, with communication indicator, length 3 meters
Mitsubishi FX3UC series PLC programming cable with FX-232AWC-H RS232 interface, RS232/RS422 interface adapter with communication indicator, length 3 meters
USB-QC30R2 USB interface Mitsubishi Q series PLC programming cable, USB/RS232 interface, cable length 3 m.

The plug on the two sides is not the same. The programming line is a USB one round and eight pins. The majority of the touch screen is the 232 serial port. The communication line is a round 8 pin, and the head is the 232 serial port male. Of course, this is certainly not the same.

See what plc, if it is 3u or you can use the convenience of 485 communication options, buy it, plug in 2 wires, and then communicate with Delta touch screen with 485.
Simply set the touch screen communication port to 422 mode. Solder the communication line according to the agreement. Finally, the touch screen is set to the same communication protocol as plc. If it is 485, remember the station number to find it.

I want to let the PLC communicate with the Delta touch screen now, but I can’t communicate with any settings. The touch screen model is: DOP-B10S411. The PLC model is; FX3U-64MT. The touch screen communication parameters are set in this way: man-machine station number: 0 communication interface: RS232 data bit:

 

1, PLC does not need to be set
2. The communication protocol is set in the Delta touch screen (RS-422, 9600, E, 8, 1)
3, RS-422 communication line is connected, you can power on